Essay REET 420 Week 3 Lab DeVry
REET 420 Week 3 Lab DeVry
REET 420 Week 3 Lab Overview
Objectives
- Given a Class A amplifier, verify the dc and ac performance.
- Understand the difference between a Class A and a Class B amplifier, and be able to calculate the resistor values to establish Class B operation.
- Be able to use an inverting amplifier using a push-pull configuration.
- Continue to develop expertise with Multisim.
Parts List
Software
- Multisim 11
Introduction
To deliver more power than is possible using op amp integrated circuits, you have to build an amplifier circuit from discrete components, including resistors, capacitors, diodes, transistors, and op amps. You can build discrete amplifiers capable of delivering several watts of power. The laboratory uses a Class A, common-drain amplifier; a Class B, push-pull amplifier; and a Class B amplifier with an op amp driver as examples. Before beginning your Lab, download your Lab cover page here (Links to an external site.).
This Lab will use the following Lab Resources:
- Virtual Lab – Citrix
Use a personal copy of the software or access the Lab Resources, go to the Course Resources page – Lab Resources section.
- When modeling the Class A, common-drain amplifier, the capacitors and the dc voltage supply are replaced with shorts. Using the circuit in the figure below, verify the dc and ac performance of the amplifier.
- Using the oscilloscope function, determine how large the output can be before it begins to distort.
- Calculate the power required by the supply and the power delivered to the load. (Show all work for full credit.)
Image Description (Links to an external site.)
- Given the circuit shown in the figure below, verify that the transistor is biased at ID = 0 Adc.
- Calculate the gate voltage, vg, when V1 = 40 Vp.
- Simulate the circuit to verify your results, and include figures of the voltage and the current readings in your report.
- Show the graph of the voltage across the output resistor R3.
- Calculate the power dissipated by the load when V1 = 40 Vp.
Image Description (Links to an external site.)
- Design an inverting amplifier to meet the following requirements.ein = +4 dBu at audio frequencies40 W to a 5 Ω loadinput impedance 4.9 k ΩTA = 40° C and Tj max = 140° Cpower supplies: ±18Vdc and ±28Vdc, each at 6 AdcShow all work. Enter the finished schematic in Multisim for full credit.
- Carefully explain how to properly configure a Class A amplifier to produce very little distortion.
- Explain the common ways to protect your amplifier design from catastrophic failure.
Stop Stressing. Your Academic Success is Guaranteed.
Domyassignment is your direct route to higher grades. Thousands of students trust our PhD-level experts to deliver 100% original, custom-written papers—from tough essays to massive dissertations.
